Then I noticed a large number of them on Ebay including a professional liquidator listing many.Ī year later I bought the same model and it welded ok. I've mentioned this before but Tapwelder may not have seen it: My first flux welder was a blue Harbor Freight 90a AC 'Mig-100' 15 years ago. And the customer can only judge quality in advance, by the manufacturer's reputation. So there can be wide differences between brands. While the E71T-GS spec shown on most brands, means whatever the manufacturer considers suitable. So the Hobart should in theory run the same as Lincoln. I just noticed that the Lincoln and Hobart flux wires are both "E71T-11, AWS 5.20" specified alloy. I could see the puddle but not the edges of puddle. The second is a.butt joining 2 1/16" steel tubes. Veritcal up capping a 6013 bead on 1/8" used machine setting deom.the panel. I thought I could use for tacking steel for gang cutting, but nope. I thought if was because my contact tip was to close as it was shorting across spatter, but it happened with a 1 in space. The only issue with the welder is it pisses our occasionally. I could not seen the edges of the puddle. I cannot believe i used to weld with this stuff. It has a jog switch inside but that was discovered after I paid attention the instructions. Must of that time was spent feeding the wire. Probably could but o have no use for this process. Thought i might be able to use it instead of stick for outside installs. Have not welded with fluxcore on about 15 yrs.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |